Electrician in Edinburg, TX

Nine electrical services for Edinburg homes and businesses

Each service below links to its own page with more detail. Every project starts with an assessment and a written estimate — no work is scheduled until you accept the quote, and every quote is specific to the conditions at your property.

Electrical Repairs

Troubleshooting and fixing outlets, switches, GFCI and AFCI devices, and faults along branch circuits in Edinburg homes. Most repair calls start with a symptom — a dead receptacle, a warm faceplate, a switch that works intermittently — and the goal is to find the actual cause rather than swap parts until it behaves.

Receptacles, switches, breakers, and fixtures that have stopped working, heat up, buzz, or trip. GFCI outlets in kitchens, baths, garages, and outdoors are common culprits when a circuit goes quiet.

We test for voltage at the device and along the branch circuit, check the neutral and grounding, and locate the fault before repairing or replacing the failed device or connection. A tripped GFCI is a reset, not a repair bill; a backstabbed receptacle that has come loose is a connection fix.

A circuit that holds under load again, with the fault identified and explained before any work is approved — so you know what was wrong and what was done about it.

Electrical Repairs details

Wiring Installation

New, replacement, and dedicated branch-circuit wiring for added loads, remodels, and equipment. When you add an appliance, an EV charger, or a dedicated laundry or kitchen circuit, the wiring has to be sized to the load and routed through a compatible raceway.

Kitchen and bath additions, laundry circuits, EV charging, outdoor runs, and dedicated appliance circuits where a shared branch circuit would be overloaded.

We size conductors to the connected load, confirm the breaker protects the wire, route wiring through compatible raceways, and verify grounding and bonding so the new circuit is safe under the load it actually carries.

Wiring matched to the equipment it feeds, with circuit capacity confirmed before the work is quoted — so the install works the first time and stays safe under load.

Wiring Installation details

Lighting Services

Indoor, outdoor, recessed, and fixture installation, replacement, and repair. Lighting work is partly about the fixture and partly about the circuit behind it — a dimmer has to be compatible with the luminaire, and an outdoor fixture has to be rated for the location.

LED luminaires, dimmers, recessed retrofits, exterior and landscape lighting, and fixture swaps throughout the home.

We match the luminaire and dimmer to the circuit, confirm the box is rated for the fixture, and set switching for how you use the space — including wet-location ratings for outdoor work.

Lighting that works with your dimmers and fixtures, installed to the conditions of each location rather than hung and hoped for.

Lighting Services details

Panel Upgrades

Service panel and breaker panel replacement, modernization, and capacity assessment. A panel upgrade is usually about capacity, condition, or safety — a full panel, an outdated load center, or one that no longer holds reliably — and the right answer starts with assessing what's actually there.

Older panels, full panels, added loads that need room, and panels that trip or show heat damage.

We assess the load center, verify grounding and bonding, and plan a replacement that fits the service and the loads you run — not a guess at amperage and not a bigger breaker on wiring that can't take it.

A panel sized to the home with clear, written scope, and the real cause of any tripping identified before a replacement is recommended.

Panel Upgrades details

Emergency Electrician

Urgent electrical issues where safe operation is in question — call to confirm current availability. We talk through the symptoms first, because the right first move for an immediate danger is different from a repair call.

Sparking, heat, smoke, a burning smell, or a fault you can't isolate. For any of those, the first step is to move away from the equipment and call 911.

We assess over the phone where we can, tell you when something is a 911 moment, and schedule an on-site visit for the repair work that follows. We don't promise a fixed response time through this site.

A clear next step for an urgent issue, with availability confirmed by phone and the safety call made first when it should be.

Emergency Electrician details

Ceiling Fan Installation

Ceiling fan mounting, balancing, and switch wiring for new or replacement fans. A ceiling fan is a moving load, so the box it hangs from has to be rated for it — a standard light box is not a fan-rated box.

Bedrooms, living areas, and patios where a fan-rated box and proper mounting are required.

We confirm the box is fan-rated, set the mounting to carry the weight and motion, and wire the switch and any remote or pull-chain control so the fan runs balanced and quiet.

A fan that runs balanced on a box rated to hold it — not just hung from whatever box was already there.

Ceiling Fan Installation details

Generator Installation

Home backup generator planning, installation, and hookup with a transfer switch. Sizing a generator starts with the loads you want to keep running, not with a kW guess, and the transfer switch and utility coordination come with it.

Standby units and portable hookups sized to the loads you actually want to back up.

We plan the load list, the transfer switch, fuel connection, and the utility and permit coordination before any equipment is ordered, so the install matches the plan.

A generator plan tied to your actual backup needs, installed and coordinated with the right parties rather than dropped off and wired up.

Generator Installation details

Surge Protection

Whole-house and point-of-use surge protective devices for panels and sensitive equipment. A surge protective device limits voltage spikes; it does not keep the power on during an outage, and we'll say that plainly.

Service-entrance protection at the panel plus point-of-use devices for electronics and appliances.

We match the device rating to the service and install it at the panel where it can protect the whole home, with point-of-use devices layered in where it matters.

Layered surge protection sized to your system — with the honest limit stated up front that it doesn't prevent outages.

Surge Protection details

Electrical Safety Inspections

Whole-home electrical inspection with written findings you can act on. An inspection here is a documented review, not a pass/fail stamp — you get a list of what we found and what to consider next.

Older homes, pre-remodel reviews, and properties you're considering buying.

We check the panel, grounding, devices, and visible wiring, then document what we find in writing so you can prioritize the work that matters.

A written list of findings and recommended next steps — not a vague assurance that everything is fine.

Electrical Safety Inspections details

What will your electrical project cost?

Your estimate reflects the assessed scope, materials, and access — the factors below shape it. A diagnostic fee may apply to troubleshooting, separate from any repair — ask about it before booking so there's no surprise.

No price on this page is a binding commitment. Final price is set by the assessed written scope, provided after an on-site assessment.

Where we work across the Rio Grande Valley

We're based around Edinburg and also serve McAllen, Pharr, Mission, San Juan, and Alamo. We don't promise a fixed radius or travel time — call to confirm we cover your address and current availability before you plan around a visit.